FREE SHIPPING IN THE US FOR ORDERS OVER $300
December 08, 2020
1. Pull the valve completely out and allow the mattress at least 15 minutes to self inflate.
2. Instead of allowing it time to self inflate, you can couple the Inflation Dry Sack with the valve for faster manual inflation. Make sure the valve is inserted in "inflate" mode, with the green center button facing out (the large, circular part of the green valve will be inside the mattress). Roll the Inflation Sack from the top to squeeze the air into the mattress. Repeat until the mattress is firm, then remove the Inflation Sack from the valve.
3. Unsnap the Inflation Dry Sack and lay on the mattress on your side, push the green valve to slowly deflate until your hip just bottoms out, so you are using the full depth of the foam. This is a great starting position to determine how firm or soft the mattress should be to work best for you. Note that most people tend to run the mattress too firm. Softer is generally more comfortable even if you sleep on a firm mattress at home. Experiment to determine what works best for you.
4. Secure the valve with the outer cap. Note if you want to adjust the pressure after the outer cap is attached, you will need to hold the valve in place when removing the cap to avoid pulling the valve completely out.
1. Pull the valve completely out.
2. Loosely roll the mattress (without folding) and push out as much air as possible. Kneel on the mattress to keep the air out while you insert the "deflation" valve, the side with the large round circular part of the valve on the outside and the green button facing to the inside of the mattress.
3. Unroll the mattress and fold it in half. Tightly roll the mattress, pushing out any remaining air. Secure the valve with the outer cap.